Service Light Reset Procedures

The following Service Light Reset Procedures are published here as described by technicians working on these cars. We cannot accept any responsibility for damage/costs incurred resulting from their use
 

Audi A4 & A6 (All years)

  • Turn off the ignition
  • Press and hold the button on the left side of the display while turning the ignition on
  • Service OIL will be displayed
  • Pull out the button on the right side of the display until the service prompt is cleared
  • The display should now read ---

If the above procedure does not work, outlined below is an alternative procedure:

  • With the ignition off, push the right button
  • Turn the ignition on and then pull the left button
  • This should clear the warning message

 


BMW 2001 to current

  • Ignition Off (Position 0)
  • Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
  • Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display*
     
  • Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
     
  • While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 seconds

Note: that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset

*Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service

 


Volkswagen (with digital Odomoter)

The code on the mileage display when you start the car will read "IN01", "IN02" or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):

  • With the key out of the ignition find and press the odometer reset button (hold down)
  • Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
     
  • Turn ignition off (button still pressed) and remove the key
     
  • Release reset button
     
  • Interval should now be reset. If this is not the case, repeat the above procedure

 


Volvo 1999-2000 - S / V / C70 Models

  • Press and Hold odometer reset button
     
  • Turn ignition switch to "run" position
     
  • After SRL flashes, release odometer reset button
     
  • Turn ignition off
     
  • Turn ignition back on to confirm reset

 


Volvo 1999-2000 - S80 Models

  • Turn ignition switch to position 1
     
  • Press and hold "day counter reset button"
     
  • Turn ignition switch to position 2
     
  • Continue holding day counter for approx. 10 seconds
     
  • After SRL flashes, release day counter button
     
  • Should hear "beep-beep" to confirm command accepted

 

We are continuing to research these procedures and will add to or update this list as further information is found.

 Back

2008 Eurotrans.